I. Overview

The 630A European style rear connector can be connected to European style front connectors or other rear connectors, providing an extended cable connection circuit (branch). It cannot be directly connected to conduit seats or through wall conduits. Its tail can be directly blocked with an insulation plug, or it can be extended to connect another European style rear joint or rear lightning arrester.

II. Performance

--When matched with suitable sleeves or plugs, provide fully shielded and fully sealed separable connections;

--Can operate underwater and under other harsh conditions for a long time;

--The built-in capacitor test point is used to determine the live state of the circuit and must be used in conjunction with a live display;

--No minimum safety distance requirement between phases; 0

--Installation can be vertical, horizontal, or at any angle.

III. Installation

--No need for any special tools, straps or fillers;

--Immediately power on and operate the cable joint after installing it on the relevant components;

--Provide standard assembly components and installation instructions.

IV. Standard packaging

--European front joint body

--Insulators (including semi conductive caps)

--Dust cap (non insulated protective cap)

--Stress cone

--Crimping terminal

--Double headed bolt

--Silicone grease, cleaning paper

--Installation instruction manual

--Product Qualification Certificate

V. Product Structure

1. Double headed bolt: Stainless steel bolts ensure a tight fit between the conductor and the sleeve.

2. Insulation layer: The unique formula and mixing technology ensure the high-quality of prefabricated EPDM insulation rubber.

3. Insulators: Epoxy resin insulators contain threaded metal parts to ensure a tight fit with double headed bolts.

4. Inner semiconductive layer: Prefabricated EPDM conductive rubber effectively controls electrical stress.

5. Stress cone: Different sizes of stress cones are used in conjunction with cable joints to ensure water tightness and cable stress release.

6. Grounding eye: pre embedded in the external shield for connecting the grounding wire.

7. Outer semiconducting layer: Prefabricated EPDM conductive rubber overlaps with the cable shielding layer to ensure continuous shielding and ensure the outer semiconducting layer

The conductive layer is in a grounded state.

8. Crimp terminals: Full copper or copper aluminum crimp terminals are suitable for copper or aluminum conductors.